Full System Cleaning in Fort Worth, TX

Every visit starts with

Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents

Worth knowing

That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.

Styles & brands we work with

‹

›

Before & after – our own jobs

‹

BeforeAfter

BeforeAfter

BeforeAfter

›

Full System Cleaning in Fort Worth, TX

Full system cleaning is a complete cleaning of every component in your home’s forced-air system: supply ducts, return ducts, the main trunk line, plenums, registers, grilles, the air handler cabinet, blower assembly, and evaporator coil housing. In Fort Worth, most homes need this level of service every three to five years – sooner if the home was recently renovated, sat vacant, or has never had documented duct work done. A full system cleaning from CleanRun Air Duct Cleaning services includes a written price before any panel comes off, a before-and-after photo record of every duct run, and a 365-Day Done Right Promise in writing.

This is a sub-service of our Air Duct Cleaning in Fort Worth program. If you’re not sure whether you need a full system clean or something narrower, call (817) 520-8797 – a live person answers, and we’ll give you a straight answer before you book anything.

When You Need Full System Cleaning

Not every duct job calls for a full system clean, but most Fort Worth homes we photograph have more going on than a single register sweep would address. Here are the situations where a full system approach is the right call:

• Post-construction or renovation debris. Drywall dust, wood particles, and insulation fibers settle deep into the trunk line and first elbows during any remodel. We regularly find 2-to-4 inch debris packs at the first elbow past the plenum in homes where contractors didn’t seal the registers during work.
• The system has never been documented. If there’s no photo record of the inside of your duct runs, there’s no way to know what’s accumulated. Fort Worth homes built before 2005 – particularly in areas like Wedgwood, Meadowbrook, and the older sections of Benbrook – frequently show 10-plus years of undisturbed buildup when the camera goes in.
• Persistent musty or dusty odor after the HVAC runs. When the smell comes back within minutes of the system cycling, the source is typically inside the plenum or the return duct trunk – not a surface issue a filter swap will solve.
• Allergy or respiratory symptoms that track with the HVAC running. North Texas allergen seasons are long – cedar and elm pollen from January through March, followed by a second grass pollen wave in May and June. Ducts that haven’t been cleaned act as a reservoir, recirculating settled pollen every time the blower runs.
• Visible mold or moisture inside a register. If a flashlight check of any register shows discoloration, a film on the liner, or standing condensation marks, the problem almost certainly extends further into the system than that one run.
• Recent rodent or pest activity. Attic entry is common in Fort Worth’s older neighborhoods, and duct interiors are a preferred nesting zone. Full system cleaning is the only way to address the debris and sanitize the liner after an infestation is resolved.

Our Full System Cleaning Process

Every full system clean follows the same documented sequence. Nothing is skipped based on the job size or the time of day. Here’s what actually happens from the time the truck arrives to the time the job record is handed over.

1. Pre-job camera inspection and written scope delivery. Before any equipment is staged, a technician runs a camera through representative duct runs and photographs the plenum, the air handler cabinet interior, and at least one return. Those images are the baseline. The written price and scope of work are delivered to you based on what the camera shows – not on a phone estimate and not on a package upsell. This is Haven Standard Clause 1: written price before work starts, every time.
2. Negative-pressure containment setup. A Nikro negative-pressure unit is connected to the system’s main trunk line before any agitation begins. Negative pressure means the system is running at lower-than-ambient air pressure, so when debris is dislodged, it moves toward the collection unit instead of back into the living space. This step is not optional and is not skipped on smaller jobs.
3. Mechanical agitation of every duct run. Each supply and return duct is cleaned with a Rotobrush rotary brush system, which physically scrubs the liner wall as it moves through the run. The brush head size is matched to the duct diameter. Flex duct, sheet metal, and fiberboard liner each require a different pressure setting – technicians adjust at the register, not from a default. The camera confirms coverage at the far end of each run before the technician moves to the next.
4. Trunk line, plenum, and air handler cleaning. The supply plenum, return plenum, and main trunk line are cleaned separately from the individual runs because debris volume in these sections is typically higher. The air handler cabinet interior – including the blower wheel and evaporator coil housing – is cleaned by hand and with compressed air where the geometry allows.
5. Register and grille cleaning. Every register cover and grille is removed, cleaned, and reinstalled. If a register was painted over (common in older Fort Worth homes) or shows rust or damage, that’s noted in the job record with a photograph.
6. Post-job camera pass and photo record delivery. After the system is reassembled, the camera goes back into the same runs photographed at the start. The before-and-after images are compiled into a documented photo record and delivered to you as part of the standard job – not as an add-on. You can see exactly what changed. If a run doesn’t photograph clean, the work isn’t marked complete.

Before

After

Full System Cleaning Pricing in Fort Worth

Full system cleaning in Fort Worth typically runs between $350 and $750 for a standard single-family home, depending on system size and what the initial camera inspection finds. That range covers the full cleaning scope described above, including the documented photo record and the 365-Day Done Right Promise. It does not include sanitizing treatments, duct sealing, or component repairs – those are quoted separately, in writing, if the camera reveals a reason to discuss them.

A few factors move the number inside that range:

• Number of duct runs. A 1,400-square-foot home in the Fairmount area with 10 supply runs and 4 returns lands at a different number than a 3,200-square-foot home in Westover Hills with 22 runs. Pricing is per-run, not per-house.
• Duct material and condition. Older fiberglass duct board and flex duct in poor condition requires slower equipment passes and lower brush pressure. The camera shows this before we price it.
• Access and attic configuration. Fort Worth’s June-through-August attic temperatures regularly exceed 130 degrees Fahrenheit, and attic-mounted systems require additional staging time for safety. Jobs scheduled in the fall and winter are generally faster to execute.
• Debris load. A system that hasn’t been documented in 15 years carries more material than one cleaned three years ago with a photo record. The camera shows the actual load before the price is written.

There is no version of this job where you receive a price after the work starts. The written price is delivered based on what the camera shows – Haven Standard Clause 1 applies to every job, including the ones where the camera finds more than expected. If CleanRun’s number sits next to a competitor’s written estimate, we’ll put both in writing under our Free Second Opinion offer at no cost to you.

Call (817) 520-8797 for a written estimate. The estimate is free, and the price you’re given before work starts is the price on the invoice when the job is done.

FAQs – Full System Cleaning in Fort Worth

How long does a full system cleaning take in a typical Fort Worth home?

Most single-family homes in Fort Worth take between three and five hours from camera inspection to photo record delivery. A 1,600-square-foot home with 12 supply runs and straightforward air handler access will typically run closer to three hours for Residential Duct Cleaning. A larger home in the Tanglewood or Rivercrest area with 20-plus runs, inaccessible trunk sections, or significant debris load will run toward five. We don’t estimate time over the phone before the camera goes in – the inspection tells us far more than the square footage does. Call (817) 520-8797 to get a written estimate that includes a realistic time window for your specific system.

What’s the difference between a full system cleaning and a standard duct cleaning?

A full system cleaning covers every component in the forced-air system: supply ducts, return ducts, trunk line, both plenums, air handler cabinet, blower assembly, evaporator coil housing, and all registers and grilles. A standard duct cleaning – especially the $79 coupon variety common in Fort Worth – typically covers only the individual duct runs and skips the air handler, the plenum, and the trunk line. The plenum is the pressurized chamber that connects the air handler to the duct network, so leaving it uncleaned means every cubic foot of air passing through the system still contacts whatever is built up there. CleanRun’s Air Duct Cleaning in Fort Worth program treats the plenum and trunk as part of the standard scope, not an upgrade.

Is full system cleaning safe for older duct systems common in Fort Worth’s historic neighborhoods?

Yes, with the right equipment and the right pressure settings. Older fiberglass duct board and deteriorating flex duct require slower brush passes and lower negative-pressure levels than sheet metal systems. The initial camera inspection shows us the liner condition before agitation begins, and equipment settings are adjusted per run. If the camera shows a section of duct that is too damaged to clean safely – collapsed flex, cracked duct board, separated joints – that section is photographed, documented in your written job record, and discussed before we proceed. We don’t clean through damage and hope it holds.

Does CleanRun clean the air handler and blower, or just the ducts?

Both, as part of a full system cleaning. The air handler cabinet interior, blower wheel, and evaporator coil housing are cleaned in every full system job. The blower wheel in particular tends to accumulate a sticky film from normal operation – airborne grease particles from cooking and airborne dust bond to the blades over time and reduce airflow measurably. Cleaning the duct runs without addressing the blower is like cleaning a water pipe while leaving the pump housing full of sediment. The before-and-after photo record includes the blower and air handler cabinet so you can see the actual condition change, not just take our word for it.

What CleanRun Delivers That You Can Verify

Fort Worth has no shortage of duct cleaning offers, and the $79 coupon is still circulating in Tarrant County ZIP codes on a regular basis. What those offers typically don’t include: a camera in the duct before the price is set, a written scope of work, a photo record you can compare run by run, or any written accountability after the truck leaves.

Here’s what a CleanRun full system cleaning job includes as standard, documented deliverables:

• Written price before work starts. Haven Standard Clause 1. No exceptions and no job-site revisions unless the camera finds a documented reason for one.
• Pre-job camera inspection images. Every duct run photographed before agitation begins.
• Documented photo record. Every duct run photographed after cleaning. Delivered to you as part of the job, not stored on a server somewhere.
• 365-Day Done Right Promise. In writing, on every job. If the work isn’t right, CleanRun makes it right – this is a written warranty, not a policy subject to manager approval.
• Background-checked, uniformed technicians. Haven Standard Clause 3: Verified Crews. Technicians are identified by name before arrival.
• Professional-grade equipment. Nikro for negative-pressure extraction, Rotobrush for mechanical agitation. These are trade-recognized brands customers can look up independently before agreeing to a price.

CleanRun has served more than 52,000 homes since 2013, and every one of those jobs started with a written price and ended with a documented photo record. Fort Worth homeowners who’ve had a coupon service done before and didn’t receive either of those things are welcome to bring that prior estimate when they call – we’ll put our own number next to it in writing under our Free Second Opinion offer.

Schedule Full System Cleaning in Fort Worth

If you’re ready to see what’s actually inside your duct system, call CleanRun Air Duct Cleaning Fort Worth at (817) 520-8797. A live person answers every call, and the first thing you’ll get is a straight conversation about what the camera is likely to show and what the written price range looks like for your home. The estimate is free, the price is in writing before any work starts, and the 365-Day Done Right Promise is on every job. Tomas Reyes and the CleanRun team are ready to put the camera in and show you exactly what’s there.

Written by Tomas Reyes, Owner at CleanRun Air Duct Cleaning Fort Worth, serving Fort Worth.